AGFA CL18 19

Settings and Printing

Installing Printer Driver

NOTES:

•If using the Network interface cable, be sure to connect the printer with a network interface cable and to turn it on.

•If using the Parallel or USB interface cable, be sure to turn off the printer or not to connect the printer with an interface cable to avoid the Plug and Play installation.

■For Windows

There are the following two methods to install the printer driver for Windows.

•Automated Driver Installation

•Custom Driver Installation

This Setup Guide only briefly explains Automated Driver Installation. For detailed instructions, refer to the Installation section.

NOTE:

•For Windows NT 4.0, Windows 2000, Windows XP and Windows Server 2003, make sure to log on as an administrator.

1 Insert the printer CD-ROM into the CD-ROM drive. The CD-ROM launches automatically.

NOTE:

•If the CD-ROM does not launch automatically, perform the following steps (1) - (2).

(1)Double-click the My computer icon. (Windows XP / Windows Server 2003: Start - My Computer)

(2)Double-click the CD-ROM icon.

2 Click Install Printer Driver.

3 Click Automated Driver Installation.

The License Agreement window is displayed.

4 Click [Yes].

The Printer port selection window is displayed.

5 [A] When using the Network interface cable: Click on Select the Network port for DP-CL18 check button, and select the printer of the IP Address confirmed on the Configuration Page (refer to “Printing the Configuration Page” on page 17).

[B]When using the Parallel interface cable: Click on Select an existing printer port check button, and click on the LPT port (Example: LPT1).

[C]When using the USB interface cable: Click on Install via the USB port (plug and play installation) check button.

6 Click [Next>].

The Installed Options window is displayed.

7 Click on the check box of the installed options in your printer and select the total memory from the Memory list, and click [Next >].

The setup program starts installing the printer driver.

8 [A] When using the Network interface cable:

(1)Click [Finish].

[B]When using the Parallel interface cable:

(1) Click [Finish] and turn the printer on.

If the Welcome to the Found New Hardware

Wizard window is displayed, refer to the

Installation section.

[C] When using the USB interface cable:

NOTE:

•For Windows 98, only Windows 98 SE is available when using a USB interface.

(1)When the Connect the printer to the computer window is displayed, connect the USB interface cable and turn the printer on.

Perform the following steps depending on the operating system:

For Windows 98 / Windows Me:

(2)When the InstallShield Wizard Complete window is displayed, click [Finish].

	displayed, click [Yes].	Settings
For Windows 2000:
(2)	If the Digital Signature Not Found window is
	The InstallShield Wizard Complete window is	and
	displayed.	and
(2)	displayed.	Printing
(2)	If the Welcome to the Found New Hardware	Printing
(3)	Click [Finish].
For Windows XP / Windows Server 2003:
	Wizard window is displayed, refer to the
	Wizard window is displayed, refer to the
	Installation section.
(3)	Click [Finish].

NOTE:

•Restarting of the computer may be required depending on your computer environment. In this case, restart your computer.

■For Windows (with Upgrade Kit)

When installing the printer driver for the printer equipped with the Upgrade Kit, use the printer CD-ROM provided with the Upgrade Kit.

The Automated Driver Installation is the same with the above steps. For detailed instructions, refer to the Installation section.