Settings and Printing
NOTES:
•Loading media exceeding the upper limit may cause a media jam or miss feed.
•When printing on envelopes, close the flap and insert with the flap side on the left side into the
•Envelopes with openings on the shorter edge cannot be used.
•When printing on some types of envelope, a wrinkle may occur. For detailed information, refer to "Envelope Specifications" in the Maintenance and Specifications section.
•When printing on transparencies, refer to “Using the
4 Pull the paper support (1) and raise (2) so that the media does not drop from the output tray.
Paper support | 1 |
| 2 |
Power On
Connect the power cord to the printer. Turn the printer on. The Power indicator lights. After the printer is ready, the Ready indicator also lights and Ready is displayed on the printer LCD panel.
NOTES:
•If Self Calibration is performed, it will take some time to complete.
•When the printer enters Power Save mode, the Power indicator will start blinking and Power Save will be displayed on the printer LCD panel.
•When you turn on the printer for the first time, it will take about 5 minutes to fill the printer with toner. When the process is completed, Ready is displayed on the printer LCD panel.
Setting the LCD Language
•English* is the default language. (* denotes the default setting.)
•Select English, German, French, Spanish or Italian as the language that appears on the LCD panel.
1 Press Menu/Exit (Pause) button to enter Menu mode.
2 Press S button until the System menu appears.
3 Press X button.
The Language menu appears.
4 Press X button.
The English* menu appears.
5 Press S button until the desired language is displayed.
6 Press Enter button to activate your selection.
Printing the Configuration Page
It is possible to confirm the printer's settings by printing the Configuration Page as below.
If the printer is connected to the network, consult with the |
| ||
network administrator for the printer’s network setting | Settings | ||
before printing the Configuration Page. For detailed | |||
| |||
information, refer to “Setting up TCP/IP on the Printer” in |
| ||
the Installation section. | and | ||
|
| ||
1 | Press Menu/Exit (Pause) button to enter Menu | Printing | |
| |||
mode.
The System Information menu appears.
NOTE:
•If the hard disk drive is installed in the printer, press S button to display the System Information menu.
2 Press X button.
The Menu Map menu appears.
3 Press S until the Configuration Page menu appears.
4 Press Enter button.
The printer will start printing the Configuration Page.
17