Model 8642A/B | Operation |
Section 3
OPERATION
INTRODUCTION TO SECTIONll
The information in this section describes both general and specific operation of the HP 8642A/B. If you have no experience with the Signal Generator, you should first read Operating Fundamentals (included with this Volume I as a separate booklet) which is intended only as a familiarization guide. Although this Section III can be used to learn basic operation, you might feel there is more information here than you need. After you read Operating Fundamentals you can use this Operation Section for additional information.
Figure 3-l in Operating Information (page 3-3) is a graphic representation of the Signal Generator’s basic operation. This figure shows most of the keys that you use to operate the instrument. Similar diagrams that show more specific functions (and their associated keys) are available on pages 3-34, 3-38, 3-68, 3-96, 3-136, 3-156, 3-166, and 3-178. Figure 3-2 on page 3-4 shows rear-panel features.
The major functions of this section are grouped as follows:
Operating Information
HP-IB Remote Operation
Detailed Operating Instructions
RF Frequency
Amplitude
Modulation
Setting Modifications
Recall Registers
Special Functions
Messages
Appendixes
Index
OPERATOR CHECKS
Since the Signal Generator performs
A flashing display indicates that an operating message is present. Refer to the tabbed Messages information later in this section for details.
rev.3OSEP88 | 3 - l |
