70
Service
Removing and Replacing Assemblies
Probe Control and Power ModuleUse the following procedure to disassemble the probe control and power module.
WARNING Hazardous voltages exist on the power supply. To avoid electrical shock, adhere closely
to the following procedures.
1Remove the power cord.
2Remove four flathead screws and remove the top cover.
WARNING Be sure to reconnect the safety ground when reassembling the instrument.
3Unplug the safety ground from the tab on the rear panel of the instrument.
4Note the orientation of the knobs. Remove the two knobs.
5On the bottom of the instrument, remove the 5mm screw that fastens the
transformer support.
6Remove the following pan-head screws.
• Three directly on the PC board.
• Two on the ac input connector.
• Two on the heatsink.
7Remove the PC board. Slide it slightly forward so parts will clear the rear panel,
then lift the rear of the board out while sliding it backwards.
8Remove the two heatsink spacers from the standoffs that were directly under
the heatsink.
9Reverse the procedure to reassemble the control and power supply.