9.Place wheel assembly without hole through hub (air valve to the outside) onto axle end having the smallest and secure with 1-5/8" dia. flat washer and 1/8" x 1-1/2" cotter pin. See figure 6. Use extra 1-5/8" diameter flat washer if needed to take up play.

11.Turn the broadcast spreader over so that it rests on its wheels.

12.Assemble the hitch bracket to the hitch tube. See figure 8. Secure with two 3/8" x 1-1/4" hex bolts, 3/8" lock washers and 3/8" lock nuts. See figure 8.

AXLE

1-5/8" DIA.

FLAT WASHER

COTTER AIR

PIN VALVE

FIGURE 6

10.Place the drive wheel onto the axle (air valve to the outside) and secure with 1/4" 1-3/4" hex bolt and 1/4" hex lock nut. See figure 7.

1/4" x 1-3/4" HEX BOLT

DRIVE WHEEL

AIR VALVE

1/4" HEX LOCK NUT

3/8" x 1-1/4" HEX BOLT

HITCH TUBE

3/8" LOCK WASHERS

3/8" HEX LOCK NUTS

HITCH BRACKET

FIGURE 8

13.Assemble the flow control link (the end with the smallest hole) to the flow control arm using one 1/4" x 5/8" hex bolt and one 1/4" hex lock nut. See figure 9. DO NOT OVER TIGHTEN, FLOW CON-

TROL LINK MUST PIVOT FREELY.

14.Place the vinyl grip on the flow control arm. See figure 9.

VINYL GRIP

FLOW CONTROL

LINK

FLOW

CONTROL ARM

1/4" HEX LOCK

NUT

1/4" x 5/8"

HEX BOLT

SMALLEST HOLE

FIGURE 7

FIGURE 9