15.Assemble the flow control arm to the flow control mounting bracket using one 1/4" x 5/8" hex bolt and one 1/4" hex lock nut. See figure 10. DO NOT

OVER TIGHTEN FLOW CONTROL ARM MUST PIVOT FREELY.

16.Hook one end of extension spring through small hole near bend in flow control rod and the other end through the hole in flow control mounting bracket. See figure 10.

FLOW CONTROL ARM

FLOW

CONTROL

 

 

LINK

FLOW CONTROL

MOUNTING

BRACKET

FLOW

CONTROL

ROD

EXTENSION

SPRING

 

1/4" x 5/8"

1/4" LOCK NUT

HEX BOLT

FIGURE 10

17.Place 1/4" flat washer on end of flow control link, align with slot in flow control mounting bracket and insert end of flow control rod through slot and hole in flow control link. Secure with 3/32" cotter pin. See figure 11.

FLOW CONTROL

18.Hook free end of flow control rod through hole in slide gate bracket located near bottom of hopper. See figure 12.

SLIDE

GATE

HOPPER BRACKET

FLOW

CONTROL

ROD

FIGURE 12

19.Assemble flow control mounting bracket to the hitch tube using two 1/4" x 1-3/4" hex bolts, two 1/ 4" flat washers and two 1/4" hex lock nuts. See figure 13. DO NOT TIGHTEN AT THIS TIME.

FLOW CONTROL

ROD

FLOW CONTROL

MOUNTING BRACKET

MOUNTING BRACKET

1/4" FLAT WASHER

3/32" COTTER

PIN

FLOW CONTROL LINK

FIGURE 11

1/4" x 3/4"

HEX BOLTS

1/4" HEX

LOCK NUTS

1/4" FLAT

WASHERS

FIGURE 13