ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Pliers

(2)7/16" Open or Boxed End Wrenches

(3)9/16" Open or Boxed End Wrenches

1.Place the spreader upside down.

2.Assemble the long spacer tube and a 3/4" washer onto the end of the axle that has the small drilled hole (right hand side). See Figure 1.

3.Place the idler wheel (no notch in hub) onto the axle. The air valve should face to the outside. See Figure 1.

4.Assemble one or two more 3/4" washers onto the axle and then assemble the 1/8" x 1-1/2" cotter pin. See Figure 1.

SHAFT

SUPPORT

SMALL PLATE

HOLE

IDLER

WHEEL

LONG

SPACER

TUBE

3/4" WASHERS

1/8" x 1-1/2"

COTTER PIN

FIGURE 1

5.Place the short spacer tube and a 3/4" washer onto the end of the axle that has the large drilled hole (left hand side). See Figure 2.

6.Place the drive wheel onto the axle. The notched hub and the air valve should face to the outside. See Figure 2.

7.Fasten the wheel to the axle using a 1/4" x 1-3/4" hex bolt and a 1/4" hex lock nut. See Figure 2.

 

SHORT

 

SHAFT

SPACER

 

SUPPORT

TUBE

1/4" x 1-3/4"

PLATE

 

 

HEX BOLT

 

 

1/4" HEX

 

LOCK NUT

DRIVE

3/4" WASHER

WHEEL

FIGURE 2

8.Remove the middle 3/8" hex bolt, flat washer and hex lock nut from the crossover tube. See figure 3.

CROSSOVER

TUBE

3/8" HEX BOLT

SHAFT

SUPPORT

PLATE

3/8" FLAT

WASHER 3/8" HEX LOCK NUT

FIGURE 3

4