16.Assemble the flow control arm to the flow control mounting bracket using a 1/4" x 3/4" hex bolt, two nylon washers and a 1/4" hex lock nut as shown in figure 7. Tighten carefully. The flow control arm should be snug, but should pivot with no more than a slight resistance.

17.Assemble the vinyl grip. See figure 7.

VYNIL GRIP

 

FLOW

FLOW CONTROL

MOUNTING

CONTROL

BRACKET

ARM

 

1/4" x 3/4"

HEX BOLT

1/4" HEX

LOCK NUT

(2)NYLON WASHERS

FIGURE 7

19.Hook free end of flow control rod through hole in slide gate bracket located near bottom of hopper. See figure 9.

SLIDE

GATE

HOPPER BRACKET

FLOW

CONTROL

ROD

FIGURE 9

20.Assemble both the flow control mounting bracket and the short handle tube to the long handle tube using two 1/4" x 1-3/4" hex bolts, four 5/16" flat washers and two 1/4" hex lock nuts. Do not tighten at this time. See figure 10.

21.Place a handle grip on each handle. See figure 10.

18.Place a 5/16" flat washer onto the end of the flow control rod. Insert the end of the rod through the slot in the flow control mounting bracket and through the hole in the flow control link. Secure with a 3/32" x 3/4" cotter pin. See figure 8.

3/32"

COTTER

PIN

5/16" FLAT

WASHER

FLOW

CONTROL

ROD

SLOT

HANDLE GRIP

1/4" x 1-3/4"

HEX BOLT

HANDLE TUBE (SHORT)

HANDLE TUBE (LONG)

FLOW CONTROL MOUNTING BRACKET

1/4" HEX

LOCK NUT

5/16"

FLAT

WASHERS

FLOW

CONTROL

LINK

FIGURE 8

FIGURE 10

6