Agri-Fab 45-02102-101 8

24. Attach an angle stop bracket and a swivel bracket

to the rear hole in the R.H. shield bracket using

a 1/4" x 3/4" hex bolt, two 5/16" washers, a ny-

lon washer and a 1/4" hex lock nut. Place the

angle stop bracket on the inside and the swivel

bracket on the outside. Tighten the locknut so

that the swivel bracket can pivot freely. See fig-

ure 13. Repeat step on L.H. shield bracket.

25. Attach a swivel bracket to the front hole in the

R.H. shield bracket using a 1/4" x 3/4" hex bolt,

two 5/16" washers, a nylon washer and a 1/4"

hex lock nut. Tighten the locknut so that the

swivel bracket can pivot freely. See figure 13.

26.Assemble the spreader shield to the front swivel brackets using two 1/4" x 3/4" carriage bolts, 5/16" washers and the two 1/4" plastic knobs. See figure 14.

27.Assemble the spreader shield to the rear swivel brackets using two 1/4" x 3/4" hex bolts, four 5/16" washers and two 1/4" hex lock nuts. Tighten the locknuts so that the swivel bracket can still pivot freely. See figure 14.

5/16" WASHER

Repeat step on L.H. shield bracket.

	5/16"	1/4" x 3/4"
	WASHER	NYLON HEX BOLT
	1/4" HEX	WASHER
	1/4" HEX	NYLON
	LOCK NUT	NYLON
		WASHER

1/4" LOCK NUT

PLASTIC

KNOB

1/4" x 3/4"

HEX BOLT

ANGLE STOP	SHIELD
BRACKET	BRACKET

SWIVEL

BRACKET

FIGURE 13

1/4" x 3/4"

CARRIAGE BOLT

FIGURE 14

28.Place the hopper screen down into the hopper to help break up clumpy material and to prevent large clumps from reaching the bottom of the hopper and clogging the opening. See figure 15.

HOPPER SCREEN

FIGURE 15