ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(2)7/16" Wrenches

REMOVAL OF PARTS FROM CARTON

Remove all parts and hardware packages from the carton. Lay out all parts and hardware and identify using the illustrations on page 3.

1.Assemble vinyl caps onto the ends of the R.H. and L.H.

Hitch Tubes. See figure 1.

2.Assemble the R.H. Hitch Tube to the spreader frame tube using two 1/4" x 2" hex bolts and 1/4" nuts. Do not tighten yet. Repeat for L.H. Hitch Tube. See figure 1.

VINYL CAP

1/4" NUT

1/4" x 2"

HEX BOLT

FIGURE 1

3.Assemble the Hitch Control Tube between the Hitch Tubes using two 1/4" x 1-3/4" hex bolts and 1/4" nuts. Tighten all bolts and nuts . See figure 2.

1/4" NUT

1/4" x 1-3/4"

HEX BOLT

FIGURE 2

4.Assemble the Hitch Brackets to the Hitch Control Tube using two 1/4" x 1-3/4" hex bolts and 1/4" nuts. Tighten.

See figure 3.

5.Assemble the hitch pin through the hitch brackets and secure with the 1/8" hair cotter pin. See figure 3.

HITCH PIN

1/4" x 1-3/4"

HEX BOLT

1/4" NUT

HAIR COTTER PIN

FIGURE 3

6.Assemble the vinyl cap onto the Hitch ControlTube.See figure 4.

7.Assemble the Control Cable to the Hitch Control Tube using the carriage bolt and nylon wing nut. See figure

4.

CARRIAGE BOLT

VINYL CAP

NYLON

WING NUT

FIGURE 4