ASSEMBLY INSTRUCTIONS

ENGLISH

 

 

9/64 x 1-1/2 in.

TOOLS REQUIRED FOR ASSEMBLY

5/32 x 2 in.

COTTER PIN (J)

COTTER PIN (I)

 

(1)

Pliers

 

5/8 in. FLAT

(2)

7/16 in. open or boxed end wrenches

 

 

WASHER (H)

 

 

 

1.Remove the spreader, the loose parts and the hardware package from the carton. Lay out parts and hardware

and identify using the illustrations on pages 2 and 3.

2. With the spreader resting upside down on the top of the hopper, assemble a 5/8 in. flat washer, a spacer and a second 5/8 in. flat washer onto each end of the axle. See figure 1.

SPACER (N)

5/8 in. FLAT WASHER (H)

FIGURE 2

6. Install an upper handle to each lower handle using four 1/4 x 1-1/2 in. bolts and nylock nuts. Do not tighten at this time. See figure 3.

FIGURE 1

3.Place a wheel onto each end of the axle. The long end of the hub goes to the inside. See figure 2.

4.Assemble a 5/32 x 2 in. cotter pin through the hole in one wheel hub and the axle. See figure 2.

5.Place a 5/8 in. flat washer onto each end of the axle and secure with a 9/64 x 1-1/2 in. cotter pin.

See figure 2.

1/4-20 x 1-1/2 in. HEX BOLT (B)

1/4-20 NYLOCK

NUT (E)

FIGURE 3