12.Insert the end of the flow control rod through the slot in the flow control mounting bracket and through the hole in the flow control lever. Secure with a 1/8 in. x 3/4 in. cotter pin. See figure 8.

1/8 x 3/4 in.

COTTER PIN (K)

FLOW

FLOW

CONTROL

CONTROL

ROD

LEVER

 

FIGURE 8

13.Install the adjustable stop on the slot in the top of the flow control mounting bracket. Secure with the

1/4 in. x 3/4 in. carriage bolt, a nylon washer, a 1/4 in. flat washer and the nylon wing nut. See figure 9.

1/4-20 WING NUT (M)

1/4 in. WASHER (F)

ADJUSTABLE

STOP (O)

1/4-20 x 3/4 in.

CARRIAGE BOLT (D)

FIGURE 9

14.Adjust the position of the flow control mounting bracket (figures 10 and 11):

a.Set the adjustable stop at “5.” Latch the flow control lever against the stop. Verify that the closure plate has opened about halfway. See figure 10.

b.If closure plate is not open halfway, adjust the position of the flow control mounting bracket until the closure plate is open about halfway at“5”and still closed when the lever is in the “OFF” position. Carefully tighten the 1/4 in. nylock nuts. Do not deform the slots in the flow control mounting bracket.

c.Push the flow control lever to the “OFF” position and ensure the closure plate closes completely.

See figure 11.

POSITION 5

ADJUSTABLE

STOP

1/4 in. NYLOCK NUTS

FIGURE 10

ADJUSTABLE

STOP

OFF

FIGURE 11