STEP 13: (SEE FIGURE 13)

Fasten the hopper braces (11) to the hopper support tubes using the nylock nuts (J) that were assembled earlier. Do not tighten completely.

Fasten the loose ends of the hopper braces to the hitch tube using a 1/4" x 2" hex bolt (C) and a 1/4" nylock nut (J). Do not tighten completely.

J 11

J

J

11

C

FIGURE 13

STEP 14:

Tighten all bolts and nuts except for those shown in step 10 that fasten the control bracket to the hitch tube.

STEP 15: (SEE FIGURE 14)

Slide a 5/8" washer (O), a spacer (L), a 5/8" washer

(O) and a wheel onto the end of the axle with no hole.

Carefully hammer a hub cap (Z) onto the axle.

Z

O L

O

STEP 16: (SEE FIGURE 15)

Slide a 5/8" washer (O), a spacer (L), a 5/8" washer

(O) and a wheel onto the end of the axle with a hole.

Attach the wheel to the axle with a 3/16" x 2" cotter pin (R).

Carefully hammer a hub cap (Z) onto the axle.

R O L

O

Z

FIGURE 15

STEP 17: (SEE FIGURE 16)

Set the adjustable stop at "5" and move the control hande back against it.

Slide the control bracket along the hitch tube until the flow plate in the bottom of the hopper is open half way.

Tighten the bolts and nuts fastening the control bracket. Do not deform the control bracket.

Make sure the flow plate will open and close all the way. Readjust if necessary.

SETTING "5"

OFF

1 2 3 4 5 6 7 8 9 10

FIGURE 14

FIGURE 16

7