ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(2)9/16" Wrenches

(2)1/2" Wrenches

(2)7/16" Wrenches

(1)Pliers

(1)Grease Gun

1.Attach the wheel support (3) to the middle of the cart bed (2) using eight 5/16 x 1-1/4" hex bolts (12) and 5/16" nylock nuts (17). Tighten.

5/16 x 1-1/4" hex bolt

3.Turn cart over and place tongue (8) on latch stand bracket (6) and wheel support (3).

4.Slide axle through wheel support and tongue.

tongue

axle

FIGURE 3

5.Assemble the step bracket (10) to the latch lock bracket (9) using two 5/16 x 3/4" hex bolts (14) and 5/16" nylock nuts (17). Tighten.

5/16 x 3/4" hex bolt

5/16" nylock nut

step bracket

wheel support

5/16" nylock nut

FIGURE 1

2.Assemble the latch stand bracket (6) to the cart bed using four 1/4 x 1" hex bolts (15) and 1/4" nylock nuts

(19). Tighten.

1/4 x 1" hex bolt

latch lock bracket

FIGURE 4

6.Slide the step bracket (10) and latch lock bracket (9) into the slot in the tongue (8).

7.Secure the step bracket (10) and latch lock bracket (9) to the tongue (8) using a 5/16 x 4" hex bolt (11), a 5/16" sims nut (18) on each side of the brackets and a 5/16" nylock nut (17). Do not over tighten nylock nut, the bolt must pivot.

8.Attach the short end of extension spring (25) to the hole at the bottom of the latch lock bracket (9).

9.Use the spring puller (27) tool to pull the long end of the extension spring (25) down and attach it to the tongue (8).

5/16" x 4" hex bolt

5/16" sims nut

5/16" nylock nut

extension spring

latch stand

1/4" nylock

bracket

 

nut

FIGURE 2

spring puller tool

FIGURE 5

4