10.Assemble a spacer (24), a 1" washer (20), a wheel (5) (valve stem facing out), and then another 1" washer (20) to the axle (4).

11.Secure with a 1/8 x 1-1/2" cotter pin (22), spreading the ends of the cotter pin with a pair of pliers bending the ends around the axle.

12.Press hub cap (23) onto washer on outside of wheel.

13.Add grease to wheel bearings using a grease gun.

14.Repeat for other wheel.

1/8 x 1-1/2"

1" washer

cotter pin

 

spacer

wheel

hub cap ADD GREASE

FIGURE 6

operation

CAUTION: Vehicle braking and stability may be affected with the addition of an accessory or attachment. Be aware of changing conditions on slopes.

do not exceed 800 lb. capacity of cart One cubic foot of dirt weighs approximately 80 lbs.

1.The maximum towing speed for this cart is 10 m.p.h.

2.Refer to vehicle owners manual for instructions on safe operation on slopes.

3.Use slope guide provided on page 13 of this manual to determine whether a slope angle is too steep for safe operation.

4.Always test to make sure your tractor has adequate towing and braking capabilities whenever hauling a substantial amount of weight in your cart. Use extra caution when operating on slopes.

5.For best handling and traction, distribute the weight of the load evenly in the cart.

6.To dump material from the cart, remove the tailgate from rear of cart and then step down on latch step bracket. After emptying, pull the front of the bed down toward the cart tongue until the latch snaps into place.

Reinstall tailgate.

CAUTION: To avoid possible injury, be sure no one is near cart before releasing latch.

15.Slide hitch into slot at end of tongue (8) and secure with a 3/8 x 1" hex bolt (13) and 3/8" nylock nut (16).

16.Assemble hitch pin (26) to hitch bracket (7) and tongue

(8) and secure with a hair cotter pin (21).

hitch pin

3/8 x 1" hex bolt

hitch bracket

3/8" nylock nut

hair cotter pin

FIGURE 7

MAINTENANCE

1.Check for loose fasteners before each use.

2.Check for worn or damaged parts before each use.

3.Keep tires filled to recommended tire pressure printed on the tire.

CAUTION: DO NOT inflate tires beyond the maximum recommended pressure printed on side of tire.

4.At the beginning of each season, using a light machine oil, lubricate the latch and the latch pivot bolt.

5.Pump grease into grease fittings on wheels periodically (at least once each season).

STORAGE

1.Clean thoroughly before storing.

2.Remove any rust from painted surfaces and coat with touch up paint.

3.Store in a dry area.

5