Aiphone KCW-D, A Video Output Control, Operations, Specifications, Toll Free Technical Support

Video Output Control:

Using a small screwdriver, adjust the Video Output Control to obtain the correct level for the CCTV device you are using. The Video Output Control is located under the rubber cover on the upper right hand corner of the KCW-D/A faceplate.

Video Output Control

Lo Hi

OPERATIONS

Using the KCW-D/A for VIDEO OUTPUT with the KC and GF systems:

1.When a call is initiated from the door station (KC) or entry panel (GF), the monitor called will ring and the picture will activate. At that time, the video signal out of the KCW-D/A adaptor will be present, and the picture can be seen on the CCTV monitor(s).

2.The video output can be connected to any receiving device that accepts a composite video signal (75 ohm, 1V peak-to-peak). This could be a standard CCTV monitor, multiplexer, or an adaptor that modulates the video onto a cable TV channel. To take the video signal directly into a TV, use a spare video input or go through the proper modulator.

NOTES:

KC System Only: When the MONITOR button on any Monitor is pressed, the video will turn on for approximately 30 seconds, and video signal will be sent to the monitor via the KCW-D/A.

GF System Only: Video is present at the KCW-D/A regardless of which monitor has been called.

Using the Demodulator to integrate a KC-DAR video door station with a standard CCTV monitor: (No audio communication or Tilt is possible with this application.)

1.To view the camera location at any time, the camera must be powered at all times, or a switch must be installed to turn it on. To do this, the PC board must be modified by adding a jumper wire in the location indicated on the

wiring diagram on page 1. Soldering is required. This modification should be done by qualified technicians only.

2.There is no Tilt control of the KC-DAR camera in this application.

3.There is no audio communication with the KC-DAR in this application.

4.If the camera is powered continually, there will always be a video output from the KCW-D/A.This application will shorten the life of the camera.

SPECIFICATIONS:
Power:	24V DC. Use Aiphone model PS-2420UL or PS-2410LC.
Current consumption:	500mA
Wire:	18AWG, 2-conductor non-shielded
	Use Aiphone wire #841802 or 871802
Wiring distance:	ALL DISTANCES ARE WITH 18 AWG WIRE.
Demodulator:	Max. 30' from monitor when used for video output.
	Max. 330' from KC door station when used with a standard monitor.
Power supply:	Max. 16' to KCW-D/A
Dimensions:	5-1/2"H x 3"W x 1-1/2"D
COAXIAL CABLE:	75 ohms, solid copper center conductor, copper braid, 95% coverage.
DC resistance:	Max. 15W per 1000 feet

Note:

Only information pertaining to the connection and operation of the KCW-D/A and connection of a standard video monitor is included here. For complete installation, wiring, and operational information, please refer to the appropriate Installation Manual.

Aiphone Communication Systems	Toll Free Technical Support:
1700 130th Ave. N.E.
	1-800-692-0200	Pg. 3
Bellevue, WA 98005
(425) 455-0510	FAX: 1-800-832-3765	KCW-D/A Instr.
FAX (425) 455-0071	E-mail tech-serv@aiphone.com	1103bkjs