| How it works |
en | |
| Your appliance |
| • washes and humidifies the air without using filter mats |
| • works quietly in two operation modes |
| |
| • is manufactured from |
| components. |
| • has a large cleansing capacity through |
| The individual dust particles are ionized (charged) and |
| stick to the humidifier discs. |
| Special humidifying discs rotate in a water bath inside the |
| unit; this cleanses the air passing over them of impurities |
| in a natural way – in the same way that air is washed by |
| the rain in nature. |
| The air humidification takes place according to the self- |
| regulating principle of cold evaporation. The appliance |
| therefore generates ideal air humidity, without the need for |
| additional control units. |
| A specially tuned |
| ver Stick®) prevents the formation of germs in the water of |
| the base unit. No chemical additives are therefore required |
| to keep the water clean. |
Unpacking
•Remove the appliance carefully from the packaging
(10 – 12). The top section is only placed on the base; it is NOT attached.
•Remove the plastic bag from the unit (13).
•Check the details of the electrical supply on the rating plate (14).
•Use the original packaging to store the appliance if you do not use it throughout the year.
10 | 11 |
12 | 13 |
14 |
Adjusting the cable length
The overall length of the cable is approx. 6,5 ft / 2 m, but this can be adjusted as required.
•Switch the appliance off and remove the power plug from the electrical supply. Do not pull on the cable (15).
•Open the cover (16 and 17)
1.Insert the screwdriver (into the whole provided)
2.Press outwards
3.Push upwards
•Pull the cable from the cable compartment (18)
•Adjust the cable length by pulling/pushing
•Store the remaining cable in the cable compartment
•Close the cover (19)