Aiwa AV-DV500 manual DOLBY PRO LOGIC cont, Adjusting Speaker Level Balance

2 Press the DOLBY PRO LOGIC button again and hold it down until the center speaker mode to be selected appears.

When selecting the DOLBY PRO LOGIC mode in step 1:

"NORMAL", "WIDE" and "PHANTOM" appear in turn.

When selecting the 3CH LOGIC mode in step 1:

"NORMAL" and "WIDE" appear one after another.

NOTE

•Depending on the sound source or listening condition, surround effect may not be obtained even when the DOLBY PRO LOGIC is on.

•The full DOLBY PRO LOGIC effect cannot be obtained when using the software without mark. In this case, use the DSP surround system instead (see page 8).

•The DOLBY PRO LOGIC system is automatically canceled when the BBE or DSP system is turned on.

DOLBY PRO LOGIC (cont.) pg. 13

ADJUSTING SPEAKER LEVEL BALANCE

The unit is equipped with a built-in test signal generator called a noise sequencer for easy balance adjustment of all four channels. The sequencer outputs a noise signal that "travels" from channel to channel, enabling the simple adjustment of sound level to achieve the same apparent loudness, at your listening position, from each channel.

1 Select the Dolby Pro Logic mode according to your current type and placement of the speakers.

(See page 12.)

2 Press the MANUAL SELECT button and hold it down for about two seconds until "L TEST" appears.