Aiwa CX-NA222 manual Press one of the function buttons to select a source, Adjust the volume

z-/

““~heunit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

Press one of the function buttons to select a source.

●If TUNER BAND is pressed, the band cannot be selected in this step.

Press TIMER repeatedly until 0 appears on the display.

5	Adjust the volume.	R
	The source sound will play at the volume level set in this step
		a.
	when the power is turned on by the timer.
		j:~j~
	If the volume level is set to 17 or higher, however, it will
		;*4JL
	automatically be set to 16 when the power is turned on.
		, ;;l
		1?! ‘+:
		,.,.
		~,., ~’‘8’
6	Prepare the source.	%
		;$%;
	To listen to a CD, load the disc to be played first on tray 1.	,;””~
	To listen to a tape, insert the tape into deck 1 or 2.	‘1 ,.
		8

To listen to the radio, tune in to a station.

d

7 Press POWER to turn off the power.

When the timer-on time is reac:hed~ the unit turns on and begins play with the selected source.

You can change the source thlat was selected in step 1 by pressing one of the function buttons before pressing ENTER or II in step 3.

To check the timer setting

Press TIMER.

The selected source, the timer-cm time, and the duration for the timer-activated period will be displayed for 4 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily Press TIMER repeatedly so that @ disappears.

To restore the timer standby mode, press again to display ~.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

a

Using the unit while the timsr i:sset

You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6.

m

m

Within 6 seconds, turn MULTI JOG to designate the timer-on time, then press ENTER or Il.

Turning MULTI JOG changes both the hour and the minute.

+or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

Within 4 seconds, turn MULTI JOG to select the duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5 minute steps.

-or E iS alSOavailable instead of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or 11 is pressed within 4 seconds after step 4.

. Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot Ibeturned on and off by the built in timer of this unit. Use an external timer.

Timer recording is applicable for TUNER and VI DEO/AUX (with an external timer) sources only.

Press either TUNER BAND or VllJEO/AUX to select a source, then press TIMER repeatedly until ~ REC appears on the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

m

You cannot use the timer functicm to record from a CD or tape.

ENGLISH 17