Aiwa CX-NAJ54 manual Setting The Clock, Dimmer Mode, Flash Window

1Press ECO.

“ECO MODE” will be displayed.

2Press ENTER within 4 seconds.

The current power-economizing mode status will be displayed.

3Turn MULTI JOG within 4 seconds to select one

of the power-economizing mode.

Example: When “ECO ON” is selected.

4Press ENTER within 4 seconds.

If the clock is not set, the unit does not black out.

Instead, the DEMO will begin when the power is turned off.

DIMMER MODE

To change the display dimmer mode

1Press ECO repeatedly until “DIM MODE” is displayed.

2Within 4 seconds, press ENTER.

3Within 4 seconds, turn MULTI JOG to select one of the dimmer modes changed cyclically as below.

4Within 4 seconds, press ENTER.

DIM-OFF DIMMER 1 DIMMER 2 DIMMER 3

“DIM-OFF” mode is the brightest and “DIMMER 3” mode is the dimmest. In “DIMMER 3” mode, the spectrum analyzer, the window of the unit top, and the button illumination light off in addition.

FLASH WINDOW

The window on the top of the unit lights up or flashes while the unit is being powered on.

To turn off the light of the top window, press s while pressing CD. To turn back on, repeat the above.

SETTING THE CLOCK PREPARATION

1Press CLOCK.

When using the remote control, press CLOCK while pressing

SHIFT.

The clock is displayed. (The “:” between the hours and minutes flashes.)

2Within 4 seconds, turn MULTI JOG to designate

the hour and the minute.

Turning MULTI JOG changes both the hour and the minute. En f or gis also available in place of MULTI JOG. Holding these buttons down will vary the time rapidly.

3Press ENTER or a.

The clock starts from 00 seconds.

To restore an original clock setting

Press CLOCK before completing step 3 to restore the previous time setting. This cancels any new setting.

To view the clock when another display is in the display

Press CLOCK. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK and then press s within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

In the 12-hour standard, “AM 12:00” indicates midnight and “PM 12:00” indicates noon.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.

If the power-economizing mode (page 6) is on, the unit blacks out when the power is turned off. To view the clock, press CLOCK so that the time is displayed for 4 seconds.

ENGLISH 7