RADIO RECEPTION
MANUAL TUNING
1Press TUNER BAND repeatedly to select the desired band.
FM 
AM 
When TUNER BAND is pressed while the power is off, the power is turned on directly.
To select a band with the remote control
Press BAND while pressing SHIFT.
2Press f DOWN or g UP to select a station.
Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for 2 seconds. During FM stereo reception, 1 is displayed.
To search for a station quickly (Auto Search)
Keep f DOWN or g UP pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops. To stop the Auto Search manually, press fDOWN or gUP.
•The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control while pressing SHIFT | SOUND | |||
so that “MONO” appears on the display. | ||||
| ||||
Noise is reduced, although reception is monaural. |
| |||
To restore stereo reception, repeat the above so that “MONO” |
| |||
disappears. |
| |||
To change the AM tuning interval | RECEPTION | |||
The default setting of the AM tuning interval is 10 kHz/step. If | ||||
| ||||
you use this unit in an area where the frequency allocation system |
| |||
is 9 kHz/step, change the tuning interval. |
| |||
Press POWER while pressing TUNER BAND. |
| |||
To reset the interval, repeat this procedure. |
| |||
|
|
| RADIO | |
|
|
| ||
When the AM tuning interval is changed, all preset stations are | ||||
| ||||
cleared. The preset stations have to be set again. |
| |||
En
ENGLISH 9
