![](/images/new-backgrounds/1018086/1808629x1.webp)
The unit can be turned on at a specified time every day with the
Preparation
Make .sLlrethe clock is set correctly.
1 Press one of the function buttons to select a source.
●[f TIJNER/BAND is pressed, the band cannot be selected in this step.
2Press TIMIER while pressing SHIFT on the remote control so that @ appears on the display.
Time and audio source name flash alternately.
o
3 Within 6 seconds, press+ or > to designate the
Pressing either button changes both the hour and the minute. Holding it dc~wnwill vary the time rapidly by
4 Within 4 seconds, press - | or E> to select the |
duration for the
The ,duration can be set between 5 and 240 minutes in 5 minute steps,
The duration will be automatically set after 4 seconds. It will also Ibeset if I I is pressed within 4 seconds after step 4.
5 Adjust the volume.
The source sound will play at the volume level set in this step when the power is turned on by the timer.
If the volume level is set to 17 or higher, however, it will automatically be set to 16 when the power is turned on.
6 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
7 Press POWER to turn off the power.
When the
8 Get ready for the tape function or the timer
recording.
To listen to the tape, press P,
To record the source, press ● on deck 1
When the
You can change the source that was selected in step 1 by pressing one of the function buttons before pressing II in step 3.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the timer recording period, ● on deck 1 is released before the timer is off.
When the tape length is longer than the timer recording period,
. is not released. If . is not released for a long time, the tape in the deck may be damaged. Press WA to release 0.
To check the timer setting
Press TIMER while pressing SHIFT on the remote control,
The selected source, the
To change any of the previous setting
Carry out from step 1.
However, if you do not change the
To cancel the timer standby mode temporarily
Press TIMER repeatedly while pressing SHIFT on the remote control to display “UOFF’.
To restore the timer standby mode, press again to display ~.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, check whether the contents in step 5 and 6 are set as you wish, turn off the power and carry out step 8 if necessary.
m
●Timer playback will not begin unless the power is turned off.
●Connected equipment cannot be turned on and off by the built in timer of this unit. Use an external timer.
K
g
.;~:”
;:;&:;, ,“& “w,
,,4 ..,,
‘:yj
.. \. 8
e
❑