Aiwa XP-R207 Q R S T, Specifications, To clean the discs → T, Connecting To An External Unit → R

1

2

3ENTER/DISP

Q

R

S

T

Each preset station is erased. All the settings move up by one and the preset numbers are refreshed.

Erasing all of the presetting

Keep ENTER/DISP pressed, then press TUNER ON/BAND when the frequency and preset number starts flashing.

CONNECTING TO AN EXTERNAL UNIT → R

Use a commercially available connection cord which has a 3.5 ø stereo mini- plug at one end and two phono plugs at the other end.

Connect the stereo mini-plug to the PHONES/LINE OUT jack of the unit and connect the phono plugs to the analog input terminals of the external unit.

Note

•Turn off the power of both units before connection.

•DO NOT connect to the PHONO inputs of an amplifier (with a built-in phonoequalizer-amplifier).

•Adjust the volume and DSL on this unit.

MAINTENANCE

To clean the lens → S

If the lens becomes dirty, the player will skip or not play. If this occurs, clean the lens in the following manner.

To remove dust or dry particles, first use a camera lens blower/brush a to blow a few times to loosen particles, then gently brush the lens b clean. Finish by blowing the lens again.

To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe gently from the center to the edge. Lens cleaning solution is commercially available.

Note

Take care not to get too much solution on the swab, which could flow into the unit and cause damage.

Pressing too strongly with the swab could scratch or break the lens.

To clean the discs → T

Before playing, wipe the disc from the center outward with a cleaning cloth. After playing, store the disc in its case.

SPECIFICATIONS

Tracking system	3-beam laser
Laser pickup	Semiconductor laser
D/A conversion	4-times oversampling digital filter + 1-bit DAC
Frequency response	20 – 20,000 Hz (47 k ohms)
Output	PHONES/LINE OUT jack (stereo mini-jack)
Frequency range	AM: 530/531 kHz – 1,710/1,602 kHz
	(10 kHz/9 kHz steps)
Maximum output	FM: 87.5 – 108 MHz
	12 mW + 12 mW (16 ohms at 1 kHz)
Power supply	500 mV (47 k ohms at 1 kHz)
	DC 3 V using two size AA (LR6) alkaline
	batteries
	DC 2.4 V using two commercially available
	(Ni-Cd 1.2 V 700 mAh) rechargeable batteries
	AC house current using the supplied AC adaptor
Maximum outside dimensions
	128 (W) ⋅ 31.2 (H) ⋅ 129.5 (D) mm (excluding
	projecting parts and controls)
Weight	(5 1/8 ⋅ 1 1/4 ⋅ 5 1/8 in.)
	Approx. 225 g (7.9 oz.) excluding batteries
Accessories	AC adaptor AC-D603 (1)
AC adaptor AC-D603U	Stereo headphones (1)
	Rated input: AC 120 V, 60 Hz

The specifications and external appearance of this unit are subject to change without notice.

XP-R207 (AU) E Page 2