Timer playback

Turns on the unit at a specified time for the specified duration. Make sure the clock is set correctly.

1Press TIMER on the remote control."5" lights up and "5PLAY" is displayed.2Within 12 seconds, press SET.3Press for gto set the timer-on time, and press SET.

Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units.

4Press for g(TUNER/BAND, AUX or E CD) to select the source, and press SET.•For timer play of a CD, select "CD".

•For timer play of a radio broadcast, select "TUNER". You will select the band later in step 7.

•For timer play of the equipment connected to the LINE IN jacks, select "AUX (VIDEO or TV)".

5Press f or g to set the timer-activated duration, then press SET.

With each press, the timer-activated duration changes in 5-minute steps between 5 to 240 minutes.

6Press for g(turn VOLUME on the main unit, or press VOLUME -,+on the remote control) to adjust the volume for timer playback, and press SET.

The volume level can be adjusted from 0 to 24.
7Prepare the source.

To play CD, load a disc. The currently selected disc is played. If you want to play a CD on another tray, play the desired CD, and then stop play.

To play the radio, select the band and tune in the desired station.

To play external equipment connected to the LINE IN jacks, set an external timer for the equipment so that its playback begins at the same time.

8Press POWER 6STANDBY/ON (POWER) to turn the unit off.

"5" remains on the display to indicate the timer standby mode (when ECO mode is deactivated).

At timer-on time, the unit turns on and plays the selected source. After the specified timer-activated duration, the unit turns off again.

•Timer playback will not begin unless the unit is turned off first.

•Connected equipment cannot be turned on or off by the builtin timer of this unit. Use an external timer.

To check the timer setting

 

Press TIMER on the remote control so that "5 PLAY"

 

appears on the display.

 

After 6 seconds, the timer-on time, the source and the timer-

 

activated duration are displayed for 6 seconds.

 

To change the timer setting

 

Reset the timer again.

En

To cancel the timer

 

Press TIMER on the remote control twice until "5 OFF" is

 

displayed. "5" disappears from the display.

 

Tip:

 

Your timer setting is retained even if the timer is cancelled.

 

Next time the timer is activated, you can change your previous

 

setting, or simply use the same setting again.

 

13