REFERENCE

Care and maintenance

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the cabinet

Use a soft and dry cloth. If the unit surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent En solution. Do not use strong solvents such as alcohol, benzine

or thinner.Care of CDs

When a CD becomes dirty, wipe it from the center out with a cleaning cloth. After playing a CD, store it in its case. Do not keep it in hot or humid places.

Troubleshooting

If your unit fails to perform properly, check the following guide and the relevant sections of the Operating Instructions.

There is no sound

•Are the speakers and AC power cord connected properly?

The unit shut off suddenly

•Possibly a short circuit in the speaker terminals. Disconnect the AC power cord from the AC outlet and reconnect the speaker cords correctly.

Erroneous display•Reset the unit. (See "Resetting the unit".)Poor radio reception•Check antenna connection. Adjust the antenna to find the best reception.•Move the unit and antenna away from other electric appliances and cords.

The CD player works poorly •Is the disc correctly loaded? •Is the disc dirty?

•Is the lens affected by condensation? If so, wait approximately one hour and try again.

Condensation

Moisture may form on the CD pickup lens when: •The unit is moved from a cold spot to a warm spot •The heating system has just been turned on •The unit is used in a very humid room

•The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

Resetting the unit

If an unusual condition occurs in the display window, reset the unit as follows:

1 Press POWER to turn off the power.

If the power cannot be turned off, disconnect the AC power cord, then plug it in again.

2 Hold down sand press POWER on the main unit. Everything stored in memory after purchase is cleared.

When transporting the unit with packing materials When transporting the unit using the packing materials, for example, when asking for repair, be sure to re-attach the protective tag, which was attached when you purchased the unit, before packing the unit. Re-attach the protective tag as described below.

1 Reset the unit while the unit is turned off. (See "Resetting the unit".)2 Press CD2 zOPEN/CLOSE to open the disc tray.3 Disconnect the AC power cord from the AC outlet.4 Attach the protective tag as illustrated.Disc tray 2

5 Connect the AC power cord to an AC outlet. 6 Press AUX to turn on the power.

7 Press POWER to turn off the power.

14