2.2Installing the Low Profile Bracket

The 100x1 Single-Port Server Adapter includes a low profile bracket to facilitate installation in a low profile slot. To install a 100x1 Server Adapter in a low profile PCI slot, the bracket on the rear of the card will need to be changed with the included low profile bracket.

1.Remove the two 4-40 x 3/16 screws bottom side of the card.

2.Install the low profile PCI bracket - P/N 9012, making sure that the mounting tabs are on the bottom side of the board and the screws secured from the component (top) side. See Figure 3 for details.

To revert a 100x1 Server Adapter from low profile to standard PCI the bracket on the rear of the card will need to be changed to the original bracket.

1.Remove the two 4-40 x 3/16 screws from the topside of the card.

2.Install the standard PCI bracket - P/N 6588, making sure that the mounting tabs are on the top (component) side of the board and the screws secured from the bottom side. See Figure 3 for details.

2-2

Alacritech 100 Series Hardware Installation Guide