Alamo A60, A72 A-Frame Assembly

ASSEMBLY

A60/A72 01/08 Assembly Section 3-2

ASSEMBLY

A-Frame Assembly

To assemble the Mower’s A-Frame, follow the procedures listed below (Figure Asm-0001):

1. Place one rear brace (3) (end with smaller hole)

to the inside of each lift lug located in the mid

section of the mower on each side of the gear-

box. Position the braces so when attached to

the lugs, the braces bend towards the center of

the mower. Align the holes of the lugs and

braces and insert a 5/8” x 1-1/2” bolt (6) and

retain with a 5/8” locknut (5). Do not completely

tighten at this time.

2. One side at a time, position an A-frame leg (2)

to the inside of a inner lift lug located in the front

of the mower. The leg must be positioned with

the smaller hole to the bottom and the bend of

the leg to the center of the mower. Align the leg

hole and inner lug back hole and retain together

with a 5/8” x 2” bolt (7) and 5/8” flat washer (8)

and locknut (5). Repeat procedure for opposite

side.

3. Position bushing (13) within the toggle link (4)

back set of holes (holes closest to bend). Raise

rear braces (3) and position against each side

of toggle link and bushing. Raise A-frame legs

and position to the outside of each rear brace.

Insert a 3/4” x 6” bolt (10) through A-frame legs,

rear braces, toggle link, and bushing and retain

with a 3/4” locknut (9).

4. Tighten all bolts and locknuts per recom-

mended torque at this time.