OPERATION
OPERATION
BEFORE leaving the Power Unit seat, always engage the brake and set the Power Unit transmission in parking gear, disengage the auxiliary hydraulics, stop the engine, remove the key, and wait for all moving parts to stop. Place the Power Unit shift lever into a low range or parking gear to prevent the tractor from rolling. Never dismount a Power Unit that is moving or while the engine is running. Operate the Power Unit controls from the operator seat only.
Use hand rails and steps when exiting the skid steer. Be careful of your step and use extra caution when mud, ice, snow or other matter has accumulated on the steps or hand rails. Use all handrails and steps for support and never rush or jump off the skid steer.
5. STARTING THE SKID STEER
The operator must have a complete understanding of the placement, function, and operational use of all skid steer controls before starting the skid steer. Review the skid steer operator’s manual and consult an authorized dealer for operating instructions if needed.
Essential Skid Steer Controls:
•Locate the light control lever
•Locate the engine shut off control
•Locate the brake pedals and the clutch
•Locate the auxiliary hydraulic control lever.
•Locate the boom height foot controls.
•Locate the hitch tilt foot controls.
Before starting the skid steer ensure the following:
•Conduct all
•Make sure all guards, shields, and other safety devices are securely in place.
•The parking brake is on.
•The skid steer transmission is in neutral.
•The auxiliary hydraulics are disengaged.
•The boom height/tilt controls are in the neutral position.
Refer to the skid steer owner’s manual for procedures to start the skid steer. Only start the skid steer while seated and belted in the operator’s seat. Never bypass the ignition switch by short circuiting the starter solenoid.
After the engine is running, avoid accidental contact with the skid steer transmission to prevent sudden and unexpected skid steer movement.
Never run the Power Unit engine in a closed building or without adequate ventilation. The exhaust fumes can be hazardous to your health.
Start the Power Unit only when properly seated in the Power Unit seat. Starting a Power Unit in gear can result in injury or death. Read the Power Unit Operator’s Manual for proper starting instructions.
SL72 03/08 | Operation Section |
© 2008 Alamo Group Inc.
