The Disc Buffing procedure is intended for the most severely damaged discs. This process, which removes a small amount of plastic from the disc, allows deeper levels of damage to be repaired.
1.Remove the pink Buffing units from the product packaging.
Note: Buffing heads must be mounted onto clear plastic bases prior to use. Use the plastic end of the brush tool to pry each of the two Repair heads into its base. Install each Buffing head onto a base, pressing down gently until they snap into place.
2.Install the assembled Buffing heads into the motorized repair unit and rotate
3.Insert the disc
4.Press the REPAIR button to begin the Buffing process.
It will run for approximately two minutes and stop automatically when complete.
5.Press the OPEN button to remove the disc, then follow with the Disc Repair Procedure (see page 6) to create a protective layer on your disc.
www.aleratec.com7