Using the 1:11 HDD Copy Cruiser IDE/SATA

Main Menu

Copy HDD

The “Copy HDD” function performs an actual copy from a source HDD to one or more target HDDs. The target HDDs must be at least as large as the source. The 1:11 HDD Copy Cruiser IDE/SATA will copy every block of capacity on the source HDD.

1.Load the source HDD and the target HDDs into the 1:11 HDD Copy Cruiser IDE/SATA. The system will auto-detect the hard drives. After the drives have been detected, a screen similar to the one below will be displayed.

1. Copy HDD

149.1GB ENT ESC

Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.

2.Press ENT to start copying. The system will auto-detect the hard drives. The following information will be displayed.

Detect Drives

Please wait...

ENT ESC

3.During the copy process the 1:11 HDD Copy Cruiser IDE/SATA will display progress information.

Copy- 36MB/s 235.7GB

0%

1:48

ENT ESC

The amount of data remaining to be transferred (shown in gigabytes), and time will be displayed as the percentage of completion increases.

Note: The copying speed, capacity and duration may vary from one source hard drive to another.

www.aleratec.com13