INSTALLATION
PRECAUTIONS
Install the
Hazardous voltages are present within the chassis. Do not remove the top panel without first unplugging the unit from AC power!
EC-1 CONNECTION TO M20 MAIN CIRCUIT BOARD
The
To connect the
1.Remove the top panel from the M20. The top panel is held to the rear panel with two Philips head screws.
2.Remove the expansion slot blank panel from the M20 rear panel. Four screws keep the blank panel in place. It is best to hold the blank panel in place when removing the screws to prevent the blank from dropping onto the main circuit board.
3.Insert the ribbon connector into the
4.Screw the
5.Replace the top panel.
To test for proper installation, plug the unit back in to AC power, turn on the M20, and press the Digital Source button (next to the meter display) until the “DIG SOURCE” group in the meter display indicates “I/O CARD”. This confirms that the M20 has detected the