5 Editing Programs
19
To Edit a Selected Program
1. Select a program to edit using the Program Up and
Down buttons, the VALUE knob or the optional
footswitches.
2. Turn the EFFECT knob to the effect module or
parameter you wish to modify.
3. Turn the VALUE knob to select an effect type
or value for the module. As soon as you
change the value, the EDITED decimal point on
the display lights up to show you a change has
been made to the current program.
4. If the module has a parameter such as DRIVE or
PARAM, turn the EFFECT knob to select the
parameter.
5. Using the VALUE knob, select a value for the
parameter.
6. Continue in this way until you have completed
assignments for all modules and parameters.
To Restore Factory Presets
Once you have saved changes to a preset program, you
can still recall the original settings. To enter the
RESTORE FACTORY PRESETS mode, simply hold
down the VALUE knob as you turn the unit on and
then select the program to be restored (or AL for all
programs). Press the VALUE knob to confirm your
selection. The display will blink rapidly several times to
indicate the restore was successful. Any program
changes you have made will be lost, so you might want
to copy the program to another location first.
J
ust turn the EFFECT
knob to exit the
RESTORE FACTORY
PRESETS mode, or
turn the unit off and
then on again.
To toggle an effect
module on and off, just
press the Program Up
and Program Down
buttons together (or
step on both
footswitches) while the
effect module is
selected.
If you return all effects
and parameters to their
previous values, the
EDITED light will go
o
ff
.
See chapter 6 for
instructions on how to
store an edited program
you’d like to save.
5 Editing Programs
20
This page intentionally left blank