Alliance Laundry Systems Drying Tumbler Topoffs, Run Mode, Close gas, Door Open Mode, End of Cycle Mode, Temperature Selector Switch, Close steam valve to steam tumbler before servicing

Operating Instructions

Run Mode

In Run Mode, the control is running a cycle. The IN USE LED is lit.

Door Open Mode

In Door Open Mode, the control turns off the heater and motor when the door is opened during a run cycle. The timer will continue to count down time and the IN USE LED is lit.

End of Cycle Mode

In End of Cycle Mode, a cycle is complete and the IN USE LED is off. The control remains in this modeuntil the door is opened or additional vend has been satisfied

Topoffs

Any time the control receives a coin drop pulse during a cycle it will add the programmed dry time to the time currently remaining in the cycle. The maximum cycle time is 99 minutes, the control will not add time beyond 99 minutes. The cool down time will not change.

If the control receives a coin drop pulse during cool down the IN USE LED will flash briefly to indicate the coin input, the machine will exit cool down and it will start heating. The cycle time will be equal to the programmed dry time

Temperature Selector Switch

For five minutes after the control is powered up, there is a diagnostic feature that allows the temperature selector switches to be tested.

When the temperature selector is changed, the new setting is displayed by flashing the IN USE LED as follows:

High/Normal: 4 flashes

Medium/PP: 3 flashes

Low/Delicate: 2 flashes

No Heat: 1 flash

NOTE: To change dipswitch settings refer to Installation Manual.

Error Codes

WARNING

To reduce the risk of electric shock, fire, explosion, serious injury or death:

•Disconnect electric power to the tumbler before servicing.

•Close gas shut-off valve to gas tumbler before servicing.

•Close steam valve to steam tumbler before servicing.

•Never start the tumbler with any guards/panels removed.

•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the tumbler is properly grounded.

		W002


Display	Definition	Corrective Action

AF (flashing)	Airflow switch opened/closed 5 or	• Check airflow switch. Replace if inoperative.
AF (flashing)	more times in a running cycle.
	more times in a running cycle.

70400101