Alliance Laundry Systems F232179R5 10

Programming

Cycle and Error Count

1.To read, enter PROGRAM Mode. Refer to Entering Program Mode.

2.Press START (Enter) keypad. Display shows “Erdn” (indicates Drain Error count).

3.Press START (Enter) keypad. Display shows a number (2 or 3 digits) showing how many drain errors have occurred. This number can range from ‘00’ to ‘255’, and cannot be set to zero.

4.Press START (Enter) keypad. Display shows “ErFL” (indicates Fill Error count).

5.Press START (Enter) keypad. Display shows a number (2 or 3 digits showing how many fill errors have occurred. This number can range from ‘00’ to 255’, and cannot be set to zero.

6.Press START (Enter) keypad. Display shows “CYC “ (indicates Cycle count).

7.Press START (Enter) keypad. Displays show a number (up to 4 digits) showing how many complete cycles have been operated. This excludes cycles stopped because of an error.

8.Press START (Enter) keypad.

9.If display does not show “E Pr”, control will revert to normal PROGRAM mode.

10.If display shows “E Pr”, this is for factory reference regarding power interruption. Press START (Enter) keypad. A number will display. Press START (Enter) keypad. After a brief pause, the control will display normal PROGRAM mode.

Setup Mode (For Earlier Models)

NOTE: In SETUP Mode, certain machine functions can be configured. The settings in this mode are related to how the machine is equipped from the factory. Usually, these would not be changed in this field.

NOTE: Enter SETUP Mode through the PROGRAM Mode.

1.Press (*) keypad. Display will show “FAr” or “CEL”.

NOTE: This selects whether temperatures display in degrees Fahrenheit (F) or Celsius (C), if control is equipped with a temperature sensor. Change selection by pressing (∧) or (∨) keypad.

NOTE: Changing degrees “FAr” or “CEL” only has an effect if the control has a temperature probe connected and/or heat capability.

2.Press START (Enter) keypad.

3.Model will display “HEAt” or “noHt”. Change the selection by pressing the (∧) or (∨) keypad.

4.Press START (Enter) keypad to continue to the next step.

NOTE: If set for “HEAt”, the control has heat capability enabled. The washer-extractor MUST have electric or steam heat and a temperature probe. If display shows “noHt” or if the message “HEAt” or “noHt” does NOT display, the control does NOT have heat capability.

5.Certain models will display “EFIL” or “ESUP”. For these models, the control provides a spare output (for certain models). The spare output can be set up to control an extra fill valve (“EFIL”), with the ability to fill to a programmable water level (just as for regular fills), OR the spare output can be set up to control an extra chemical supply signal (“ESUP”).

6.Press START (Enter) keypad.

7.Certain models display “bEEP” (control sounds beeper during Add Bleach [Supply 2]) or “nobP” (control does NOT sound beeper during Add

Bleach [Supply 2]). Change selection by pressing (∧) or (∨) keypad.

8.Press START (Enter) keypad.

NOTE: If “EFIL” or “ESUP” does NOT display, the extra fill capability is NOT present. If either message does display, change the selection by pressing the (∧) or (∨) keypad. Press START (Enter) keypad to return to PROGRAM Mode. Refer to “Programming Cycle Segments” section for additional information.

F232179