Programming
Test Cycle (Continued)
l.The cold water fill valve turns off. The recirculation pump output is energized for ten seconds, provided that the water level switch indicates that at least low water level is present. The display shows “PUnP” (recirculation pump output on).
m. The motor rotates clockwise (in reverse) at reduced wash speed for 60 seconds. The display alternately flashes “SLo” and “rEv” (normal wash speed, clockwise).
n.The motor rotates counterclockwise (forward) at reduced wash speed for 60 seconds. The display alternately flashes “SLo” and “For” (reduced wash speed, counterclockwise).
o.The motor rotates clockwise (in reverse) at normal wash speed for 60 seconds. The display alternately flashes “norM” and “rEv” (normal wash speed, clockwise).
p.The motor rotates counterclockwise (forward) at normal wash speed for 60 seconds. The display alternately flashes “norM” and “For” (reduced wash speed, counterclockwise).
q.The display begins alternately flashing “drAI” and “For” (drain step, cylinder rotating at wash speed). The motor continues to rotate counterclockwise (forward) at normal wash speed for seven seconds.
r.The motor accelerates to distribution speed. The display alternately flashes “drAI” and “dISt” (drain step, cylinder rotating at distribution speed).
s.The drain opens 15 seconds into the drain step. The water level indicator lights on the display will begin to go out, one by one, as the machine drains past each water level.
t.The computer begins monitoring the balance signal from the AC inverter drive eight seconds after the water level switch indicates that water level has dropped below low level.
u.If the balance signal indicates that the wash load is unbalanced, the cylinder will slow down to wash speed for seven seconds in an attempt to redistribute the load. The computer will make as many as ten attempts, as needed, in this cycle.
Note: If the machine utilizes the overtravel limit switch balance detection system, the computer will proceed through the drain step and will time steps t and u. The computer will then proceed to step v.
v.The cylinder accelerates to low spin speed. The display shows “SPn1” (cylinder rotating at low spin speed). The basket rotates at low spin speed for 60 seconds.
w.The cylinder accelerates to medium spin speed. The display shows “SPn2” (cylinder rotating at medium spin speed). The basket rotates at medium spin speed for 60 seconds.
x.The cylinder accelerates to high spin speed. The display shows “SPn3” (cylinder rotating at high spin speed). The basket rotates at high spin speed for 60 seconds.
30 | F232072 |