Programming
Cycle Programming (Continued)
7.Use the Up or Down key to select the desired supply option. See the table below.
| Supply Options | |
|
|
|
Display |
| Supply |
|
|
|
SUP0 |
| No Supply |
|
|
|
SUP1 |
| Supply 1 |
|
|
|
SUP2 |
| Supply 2 |
|
|
|
SUP3 |
| Supply 3 |
|
|
|
SUP4 |
| Supply 4 |
|
|
|
SUP5 |
| Supply 5* |
|
|
|
SUP6 |
| Supply 1 and 5* |
|
|
|
SUP7 |
| Supply 3 and 4 |
|
|
|
*This is available only if the “SUP5”/“AFIL” SETUP option is set to “SUP5.”
8.Press the Start key.
9.If the
10.Use the Up or Down key to select the desired drain option. If “drAI” is selected, the machine will drain after the segment time has elapsed. If “nodr” is selected, the machine will not drain and the spin step will be skipped entirely. Press the Start key.
Note: The drain step in the final program segment cannot be skipped.
11.Final “FIL9” spin only. Use the Up or Down key to select the desired spin speed. See the table below.
| Spin Options | |
|
|
|
Display |
| Spin Speed |
|
|
|
SPn1 |
| Low Spin |
|
|
|
SPn2 |
| Medium Spin |
|
|
|
SPn3 |
| High Spin |
|
|
|
12.Press the Start key.
13.Use the Up or Down key to select the desired spin time. Set this value to zero to skip the spin step. Press the Start key. The display will now show the identifier for next program segment or cycle option.
Note: Every intermediate spin is followed by a
14.Press the Stop key at any time to complete the cycle programming procedure.
Test Cycle
1.Verify that the RUN/PROGRAM mode toggle switch is in the RUN position.
2.Press the Up or Down key until the display alternately flashes “tESt” and “CYC,” indicating that the test cycle is selected.
3.Press the Start key to begin the test cycle.
28 | F232072 |