1.Press the Up key until the computer display shows the segment to be edited. Press the Start key.

2.Use the Up or Down key to select the desired segment time. Set this value to zero to skip the segment. Press the Start key.

Note: The computer does not count down the remaining cycle time during fills, drains, cool- down, or prior to first achieving the programmed heat temperature when heating. The computer resumes counting down cycle time once the programmed fill level is reached, when the machine has drained, and after a programmed heat temperature is reached.

3.If the temperature-controlled fill SETUP option is enabled, the display will show “tFIL.” Press the Start key.

4.Use the Up or Down key to select the desired fill temperature. See the following table for fill options.

Fill Temperature Options

Display

Fill Type

 

 

CFIL

Cold fill

 

 

HFIL

Hot fill

 

 

bFIL

Warm fill

 

 

AFIL

Auxiliary fill*

 

 

*This is available only if the “SUP5”/“AFIL” SETUP option is set to “AFIL.”

Programming

If the temperature-controlled fill SETUP option is enabled and a target temperature is set, the selected fill valve(s) will energize for the first 3 seconds of the segment fill. The computer will then begin operating the fill valves in an attempt to reach the target temperature. Press the Start key.

Note: If “AFIL” is selected and the temperature- controlled fill SETUP option is set to “tFIL,” the temperature for the segment must be set to zero.

5.Use the Up or Down key to select the desired fill level. See the table below.

Water Level Options

Display

Fill Level

 

 

LO

Low Level

 

 

Med

Medium Level

 

 

HI

High Level

 

 

6. Press the Start key.

F232072

27