Version 3.0.0.33
When the master was lost (powered down) the SFP port(s) on backup changed to DOWN
– link changed to half duplex and remained down. This issue has been resolved.
Version 3.0.0.32
Unregistered Multicast - when a user configures unregistered multicast to be filtered then broadcast packets were mistakenly also identified as unregistered multicast and therefore were also filtered (CQ ID 112258)
DVA - When the bridge address table is full and unregistered multicast are set to be filtered the device fails with fatal error (CQ ID 112338)
The MAC groups mapping is not working for IGMP packets (CQ ID 89459)
Guest VLAN should be accessible only after timeout/fail authentication (CQ ID 68048)
Dynamic VLAN assignment need to allow support for tag<>0 in attribute [81] Tunnel-
Command qos
Traffic shaping should not be applied if port is in half duplex (CQ ID 106326)
FE/GE ports, Storm control range of supported values is incorrect in the CLI guide (CQ ID 108733)
In order to get a clean, functional compile using Castlerock SNMP need to make a few changes to the MIB files (CQ ID 109360)
SYSLOG - on EWS system/event log modify tab “minimum severity” should be changed to”facility” (CQ ID 111154)
SNMPv1/2 - MIB file: Some mib files compile error (CQ ID 111073)
SNTP - After enabling SNTP via EWS, the SNTP Unicast Clients and Unicast Clients polling is still not enabled (CQ ID 110764)
EWS - At standalone DUT, EWS will display
Diagnostic LED - The Diagnostic LED Indications in Table 7 on Page 20 of the
LED Description | LED Indication | Description | |
|
|
| |
|
|
| |
Diag | Green | System Diagnostics in progress. | |
|
| ||
Off | System Diagnostics successfully completed. | ||
| |||
|
|
|
Features History
Version 3.0.0.40
Dot1x Legacy compliant
This is an advanced 802.1x configuration enabling support for
PN | 9 | Allied Telesis, Inc. |
