AR750S-DP Secure VPN Router
20
5. Use the CLI to continue configuring the router.
See the AR700 Series Router Software Reference for details about commands
available for configuring the router (including a list of message definitions).
To display a list of help topics, enter:
help
To display help on a specific topic, enter:
help topic
Alternatively, type a question mark (?) at the end of a partially completed
command to see a list of valid options.
AR750S-DP Default Configuration
The default configuration file boot.cfg loads automatically when the router starts.
This file is stored in the router’s flash memory.
You can restart the router with the default configuration by either pressing the
Reset button on the front panel of the router, or using the command:
restart router config=none
If the boot.cfg file has been removed, the router restarts with no configuration.
We recommend leaving boot.cfg unchanged, so that you can revert to the original
configuration if necessary.
Figure 1: Default configuration file for the AR750S-DP router
# IP Configuration
#
ena ip
add ip int=vlan1 ip=192.168.1.1 mask=255.255.255.0