Allied Telesis AT-8100S/48POE, AT-8100L/8POE-E manual Figures

Figures

Figure 1: Front Panels of the 8100L Series Switches	23
Figure 2: Networking Ports and SFP Slots on the 8100L Series Switches	23
Figure 3: Front Panels of the 8100S Twisted Pair Series Switches	25
Figure 4: Networking Ports and SFP Slots on the 8100S Series Switches	26
Figure 5: Front Panels of the 8100S Fiber Optic Series Switches	28
Figure 6: Front Panels of the 8100S Fiber Optic Series Switches (Continued)	29
Figure 7: Back Panels of the Single Power Supply Switches	30
Figure 8: Back Panels of the Dual Power Supply Switches	31
Figure 9: 8100L Series Management Panel	32
Figure 10: 8100S Series Management Panel	32
Figure 11: Model Naming Conventions for the Twisted Pair 8100L and 8100S Series Switches	33
Figure 12: Model Naming Conventions of the Fiber Optic 8100S Series Switches	33
Figure 13: 10/100Base-TX Port LEDs	47
Figure 14: 10/100/1000Base-T Port LEDs	48
Figure 15: 100Base-FX Port LED	49
Figure 16: SFP Slot LEDs	50
Figure 17: Stacking Port S1 and S2 LEDs	51
Figure 18: Stack ID LED	52
Figure 19: Components of the 8100L Series Switches	65
Figure 20: Components of the 8100S Series Switches	66
Figure 21: Components of the AT-8100S/24C Switch	67
Figure 22: Turning the Switch Upside Down	71
Figure 23: Removing the Rubber Feet	71
Figure 24: Attaching the Brackets to Install the Switch in an Equipment Rack	72
Figure 25: Attaching the Brackets to Install the Switch in an Equipment Rack (Continued)	73
Figure 26: Attaching the Brackets to 8100L and AT-8100S/24C Switches for Equipment Rack Installation	74
Figure 27: Attaching the Brackets to 8100L and AT-8100S/24C Switches for Equipment Rack Installation (Continued)....	75
Figure 28: Mounting the Switch in an Equipment Rack	75
Figure 29: Removing the Dust Plug from an SFP Slot	81
Figure 30: Installing an SFP Transceiver	81
Figure 31: Removing the Dust Cover from the SFP Module	82
Figure 32: Positioning the SFP Handle in the Upright Position	82
Figure 33: Connecting the Fiber Optic Cable to the SFP Module	83
Figure 34: Plugging in the AC Power Cord	86
Figure 35: Switch Initialization Messages	89
Figure 36: Switch Initialization Messages (Continued)	90
Figure 37: DC Terminal Block	92
Figure 38: Stripped Wire	92
Figure 39: Inserting Wires into the DC Terminal Block	93
Figure 40: Connecting the Management Cable to the Console Port	95
Figure 41: AlliedWare Plus Command Line Prompt	97
Figure 42: Moving to the Global Configuration Mode with the ENABLE and CONFIGURE TERMINAL Commands	97
Figure 43: STACK Command Confirmation Prompt	98
Figure 44: PORT Parameter in the Command Line Interface	101
Figure 45: RJ-45 Socket Pin Layout (Front View)	111
Figure 46: Stacking Port Pin Layout (Front View)	114

9