Packard Bell NS1 1HR manual Index of error messages, Error codes, Error messages

		www.packardbell.com
Index of error messages
Error codes
Error Codes	Error Messages
006	Equipment Configuration Error
	Causes:
	1. CPU BIOS Update Code Mismatch
	2. IDE Primary Channel Master Drive Error
	(The causes are shown before “Equipment Configuration Error”)
010	Memory Error at xxxx:xxxx:xxxxh (R:xxxxh, W:xxxxh)
070	Real Time Clock Error
071	CMOS Battery Bad
072	CMOS Checksum Error
110	System is disabled. An incorrect password was entered.
<No error code>	Battery is critically low. In this situation BIOS issues four short beeps, then shuts the system
	down. No message is displayed.
<No error code>	Temperature is critically high. In this situation BIOS shuts the system down. No message is
	displayed.
Error messages
Error Messages		FRU/Action Sequence
Failure Fixed Disk		■	Reconnect the hard disk drive connector.
		■	Run “Load Setup Defaults” using the BIOS Setup Utility, then reboot
			the notebook.
		■	Test or replace the hard disk drive.
		■	Test or replace the system board.
Stuck Key		See “Testing the keyboard or auxiliary input device” on page 99.
Keyboard error		See “Testing the keyboard or auxiliary input device” on page 99.
Keyboard Controller Failed		See “Testing the keyboard or auxiliary input device” on page 99.
Keyboard locked - Unlock key switch		Unlock the external keyboard.
Monitor type does not match CMOS - Run Setup		Run “Load Setup Defaults” using the BIOS Setup Utility, then reboot the
		notebook.
Shadow RAM Failed at offset: nnnn		■	Test or replace the BIOS ROM.
		■	Test or replace the system board.
System RAM Failed at offset: nnnn		■	Test or replace the SO-DIMM.
		■	Test or replace the system board.
Extended RAM Failed at offset: nnnn		■	Test or replace the SO-DIMM.
		■	Test or replace the system board.
System battery is dead - Replace and run Setup		Test or replace the CMOS battery, run the BIOS Setup Utility to
		reconfigure system time, then reboot the system.
System CMOS checksum bad - Default		Test or replace the CMOS battery, run the BIOS Setup Utility to
configuration used		reconfigure system time, then reboot the system.

103