Packard Bell NS1 1HR manual

www.packardbell.com

8Remove the screws securing the palm rest and keyboard frame to the base side.

9Remove the palm rest by performing steps 9 – 13 of the “Replacing the palm rest module” procedure on page 48.

10Locate the small gaps on the top side of the keyboard frame and insert a small flat-blade screwdriver or non-marring scribe into each gap to separate the keyboard frame from the base enclosure.

11Once the top side is separated, pry loose the left and right sides of the keyboard frame, until all the retaining tabs have been released.

12Flip the keyboard over to access to the keyboard cable (1).

13Unlock the system board’s keyboard cable connector (2), and then remove the cable (3).

55