www.packardbell.com

Replacing the USB board

Tools you need to complete this task:

Phillips #0 screwdriver

Flat screwdriver

or

Non-marring plastic scribe

Screws removed during this task:

3 black M2.5×6 (bay cover)

1 black M2×3 (hard drive)

1 black M2.5×6 (optical drive)

9 black M2.5×6 (palm rest - base side) - Indicated by A in step 8 of the “Replacing the palm rest module” procedure on page 48

To replace the USB board:

1Complete the steps in “Preparing the notebook” on page 37.

2Complete the steps in “Removing the battery” on page 38.

3Remove the hard drive by performing steps 3 and 4 of the “Replacing the hard drive” procedure on page 41.

4Remove the optical drive by performing steps 3 and 4 of the “Replacing the optical drive” procedure on page 46.

5Remove the palm rest by performing steps 8 13 of the “Replacing the palm rest module” procedure on page 48.

6Unlock the two USB board cable connectors (1), and then remove the USB board cables (2).

63

Page 69
Image 69
Packard Bell NS1 1HR manual Replacing the USB board