www.packardbell.com
65
Replacing the Bluetooth module
Tools you need to complete this task:
Screws removed during this task:
•3 black M2.5×6 (bay cover)
•1 black M2×3 (hard drive)
•1 black M2.5×6 (optical drive)
• 9 black M2.5×6 (palm rest - base side) -
Indicated by A in step 8 of the “Replacing the palm rest module” procedure
on page 48
To replace the Bluetooth module:
1Complete the steps in “Preparing the notebook” on page37.
2Complete the steps in “Removing the battery” on page38.
3Remove the hard drive by performing steps 3 and 4 of the “Replacing the
hard drive” procedure on page 41.
4Remove the optical drive by performing steps 3 and 4 of the “Replacing the
optical drive” procedure on page 46.
5Remove the palm rest by performing steps 8 – 13 of the “Replacing the palm
rest module” procedure on page 48.
6Disconnect the Bluetooth cable from its system board connector (1), and then
detach the Bluetooth module (2).
7Place the new Bluetooth module on the system board and reconnect the
Bluetooth cable to its system board connector.
8Reinstall the keyboard by performing steps 21 – 24 of the “Replacing the
keyboard” procedure on page 53.
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe