CHAPTER 3: Replacing notebook components

Replacing the webcam

Tools you need to complete this task:

Phillips #0 screwdriver

Flat screwdriver

or

Non-marring plastic scribe

Screws removed during this task:

3 black M2.5×6 (bay cover)

1 black M2×3 (hard drive)

1 black M2.5×6 (optical drive)

5 black M2×3 (keyboard frame - top base side) - Indicated by A in step 8 of the “Replacing the keyboard” procedure on page 53

13 black M2.5×6 (keyboard frame/palm rest module - base side) - indicated by B in step 8 of the “Replacing the keyboard” procedure on page 53

1 black M2×3 (system board)

4 black M2.5×6 (LCD panel hinges)

2 black M2.5×5 (LCD front panel)

To replace the webcam:

1Complete the steps in “Preparing the notebook” on page 37.

2Remove the LCD panel assembly by performing steps 2 12 of the “Replacing the LCD panel assembly” procedure on page 76.

3Remove the LCD front panel by performing steps 3 5 of the “Replacing the LCD front panel” procedure on page 79.

4Disconnect the webcam cable (1), and then pry the board from the LCD assembly lid (2).

82

Page 88
Image 88
Packard Bell NS1 1HR manual Replacing the webcam