CHAPTER 3: Replacing notebook components
Note
A circuit board that is >10 cm2 has been highlighted with a yellow rectangle as shown in the above image. Follow the local regulations for disposing this type of circuit board.
9Observing the same orientation as the old touchpad board, secure the new board on the palm rest.
10Cover the new touchpad board with the
11Insert the touchpad cable to the touchpad board cable connector, and then close the clip to lock the cable in place.
12Reinstall the palm rest module by performing steps 14 – 17 of the “Replacing the palm rest module” procedure on page 48.
13Reinstall the optical drive by performing steps 10 and 11 of the “Replacing the optical drive” procedure on page 46.
14Reinstall the hard drive by performing steps 8 and 9 of the “Replacing the hard drive” procedure on page 41.
15If you have disconnected any wireless antennas, reconnect them now.
16Reinstall the bay cover.
17Reinstall the battery.
52
