Allied Telesis AT-9000 manual Resolved Issues

AlliedWare Plus Version 2.1.2 Software Release Notes

— VLAN stacking

Use the command line interface to configure these features.

ˆThe web browser interface has been tested and found to be compatible with the following web browsers:

—Microsoft Internet Explorer 7 and 8

—Mozilla Firefox 3.6.3

—Apple Safari 4.0.5

Note:

If you are using Explorer 8 web browser and the pull-down menus in the switch’s web browser interface do not work, open the Internet Options window in the web browser, select the Security tab, and set the custom settings to medium-high. Then refresh your page.

ˆYou cannot change the configuration of a port, such as its VLAN assignment, after it is added to a static or an LACP trunk. The configuration of a port must be set before it is added to a trunk.

ˆYou can create up to 4096 VLANs on the switch, but only 255 VLANs can be active at a time.

ˆChanging the SNMPv3 engineID value is not recommended because the SNMP server on the switch may fail to operate properly.

Resolved Issues

The following issues were resolved in this release.

ˆSNMP server: The SNMP server stopped working during SNMP walks. (8222)

ˆSNMP server: The SNMP server stopped working if you activated the HTTP or HTTPS server and reset the switch. (8148)

ˆSNMP and Telnet servers: A memory leak problem in the SNMP and Telnet servers caused the switch to reset after forty management sessions. (8318)

ˆSNMP server: Access control lists created with SNMP were deleted by the switch. (8651)

ˆSNMP server: The switch displayed debug messages during local management sessions if there was also an active SNMP session. (8646)

ˆSNMP server: The switch periodically displayed an IPC_TIMEOUT_ERROR message when it was managed with SNMP. (8201)

ˆSNMP traps: The switch sent SNMP traps even when they were disabled. (8650)

ˆPort configuration: The SHOW INTERFACE command displayed negative numbers. (8263)

ˆSNTP client: The CLOCK TIMEZONE command did not accept minutes in its format. (8145)

ˆSNTP client: The SHOW NTP ASSOCIATIONS command did not display the UTC offset correctly. (8196)

ˆSNTP client: System time drifted forward if it was set by an NTP or SNTP server. (8612)

ˆSNTP client: The NTP client did not synchronize properly with the Microsoft Windows XP Time server. (8626)

ˆSNTP client: The client periodically caused the switch to stop forwarding network traffic. (8637)

PN 613-001447 Rev A 7 Allied Telesis, Inc.