AlliedWare Plus Version 2.1.2 Software Release Notes
SET SFLOW COLLECTOR IP Command - In v2.1.1 this command in the Port Interface mode was used to identify the sFlow collector that was to be the recipient of packet data from a port. This command is not supported in v2.1.2 because you may specify only one sFlow collector for the switch. The collector is identified with the SFLOW COLLECTOR IP command in the Global Configuration mode.
IP
Troubleshooting the Upgrade Procedure
If you have a problem downloading the management software to the switch from your TFTP server, here are a few suggestion on how to resolve it:
Check that the TFTP server on your network is active.
Use the SHOW IP INTERFACE command in the User Exec or Privileged Exec mode to verify that the switch has an IP address.
Use the PING command in the Privileged Exec mode to check for an active link between the switch and your TFTP server.
Verify that you entered the COPY command correctly. Be sure to include the “.img” extension in the filenames of the management software file.
If you are using a TFTP server that is case sensitive, be sure to use upper and lowercase characters when specifying filenames in the commands.
Check that the management software file is stored in the correct directory on the TFTP server.
Operational Notes
The speed of the
awplus> enable
awplus# configure terminal awplus(config)# interface port1.0.1
The assignment of an IPv6 management address to the switch must be performed manually using the IPV6 IPADDRESS command, because the switch cannot obtain an IPv6 address with stateless autoconfiguration or from a DHCP6 server.
You cannot use the web browser interface to configure these features:
—Access control lists
—Enhanced stacking
—Quality of Service
—SNMP
—Voice VLANs
PN | 6 | Allied Telesis, Inc. |