Allied Telesis AT-AR021 (S)BRI-S/I manual Port Interface Card, Manager set voip public int=eth0

10 Port Interface Card

6.Load the protocol image onto the PIC.

To load the protocol image, use the command:

enable voip protocol={h323sip} [engine={engine}]

The boot code loads the protocol onto all AT-AR027 PICs unless you specify an individual PIC (engine). The engine name is formed by concatenating a VoIP interface type and an engine instance (for example, fxs2). A fully qualified engine name may also be specified (for example, bay0.fxs0 or nsm0.bay1.fxs0).

Once the firmware is loaded, all the LEDs turn off. The following figure shows an example of the firmware download process. User input is shown in bold.

Manager> set voip boot=c-1-0-0.bin server=10.32.16.115 Info (1110003): Operation successful.

Manager> set voip fi=hs-1-0-0.bin protocol=h323

Info (1110003): Operation successful.

Manager> set voip public int=eth0

Info (1110003): Operation successful.

Manager> ena voip protocol=h323

Info (1110282): VoIP PIC BAY0:Firmware is loading...

Info (1110282): VoIP PIC BAY1:Firmware is loading...

Manager>

Info (1110293): VoIP PIC BAY0:Firmware successfully loaded. Manager>

Info (1110293): VoIP PIC BAY0:Firmware is now running. Manager>

Info (1110293): VoIP PIC BAY1:Firmware successfully loaded. Manager>

Info (1110293): VoIP PIC BAY1:Firmware is now running.

7.Save the configuration.

Save your configuration to a new file by using the command: create config=filename.cfg

Then set the router to load this file when it restarts by using the command: set config=filename.cfg

We recommend leaving the boot.cfg file unchanged, in case you need to revert to the original default configuration.