4.6.3.4 Enable Incoming ICMP Ping
Enabling the Incoming Internet Control Message Protocol (ICMP) Ping will allow Echo requests to come into the gateway. The gateway will respond with a ICMP Echo response message. The option allows the ADSL Provider or ISP to determine the following:
a.The status of the network.
b.Tracking and isolating hardware and software problems.
c.Testing, measuring and managing networks.
4.6.4Access Control
Access control can also be called port blocking. Specific types of traffic that is destined to a selected LAN IP address can be blocked. To enable any of the Access Control features, click Advanced and under Advanced, select Access Control. A page similar to the port forwarding page appears. Similar to the port forwarding page, a IP address can be added to a rule. All Access Control rules have precedence over rules that were added via the port forwarding page.
The Apply button will temporarily save this connection. need to click on Save Settings (at the side of the page). Save All.
To make the change permanent, you At the system commands page, click on
4.6.5 LAN Clients
To add a LAN client, click Advanced and under Advanced, select LAN Clients. If DHCP is used, all DHCP clients are automatically assigned. If a fixed IP address server is on the LAN and you want this server to be visible via the WAN, you must add its IP address. Once the IP address has been added, you can apply Port Forwarding and Access Control rules to this IP address.
The Apply button will temporarily save this connection. need to click on Save Settings (at the side of the page). Save All.
To make the change permanent, you At the system commands page, click on
4.6.6 MAC Address Filters
The MAC filtering mechanism provides a way for the users to define rules to allow/deny frames through the bridge based on source MAC address, destination MAC address and/or frame type. When bridge filtering is enabled, each frame is examined against the defined filter rules sequentially, and when a matched is determined, the appropriate filtering action (determined by the access type selected . . . i.e. allow or deny) is performed. The user should note that the MAC filter will only examined frames from interfaces that are part of the bridge itself. Twenty filter rules are supported with MAC filtering. To enable MAC Filters, click Advanced and under Advanced, select MAC Filters. Figure 15 illustrates a typical Bridge filter configuration.
The User Interface for MAC Filter allows the user to add/edit/delete, as well as, enables the filter rules. To add rules, simply define the source MAC address, destination MAC address and frame type with desired filtering type (i.e. allow/deny), and click the “Add” button. The MAC address must be in the
To edit/modify an existing filter rule, select the desired rule created previously from “Add” in the “Edit” select box. The selected filter rule will appear on the top section, as with the “Add” filter rule. Make the desired change to the MAC address, frame type and/or access type, and click “Apply”.
To delete filter rule(s), select the filter rule entry to delete in the “Delete” selection box. Note that multiple deletions are possible. Once all the desired filter rule(s) is/are selected for deletion, click
- 24 -
